Most serial (UART) ports on a Pixhawk board can be fully configured via parameters
(exceptions are ports that are used for a very specific purpose like RC input, or which are not configurable like
The configuration makes it easy to (for example):
- change the baudrate on a port.
- run MAVLink on a different port, or change the streamed messages.
- setup dual GPS.
- enable sensors that run on a serial port, such as some distance sensors.
The following functions are typically mapped to the same specific serial ports on all boards, and are hence mapped by default:
- MAVLink is mapped to the
TELEM 1port with baudrate 57600 (for a telemetry module).
- GPS 1 (gps driver) is mapped to the
GPS 1port with a baudrate Auto (with this setting a GPS will automatically detect the baudrate - except for the Trimble MB-Two, which requires 115200 baudrate).
All other ports have no assigned functions by default (are disabled).
All the serial drivers/ports are configured in the same way:
- Set the configuration parameter for the service/peripheral to the port it will use.
Configuration parameter names follow the pattern
\*\_CFG(QGroundControl only displays the parameters for services/drivers that are present in firmware). At time of writing the current set is: GPS_1_CONFIG, GPS_2_CONFIG, ISBD_CONFIG, MAV_0_CONFIG, MAV_1_CONFIG, MAV_2_CONFIG, RTPS_CONFIG, RTPS_MAV_CONFIG, TEL_FRSKY_CONFIG, TEL_HOTT_CONFIG, SENS_LEDDAR1_CFG, SENS_SF0X_CFG, SENS_TFMINI_CFG, SENS_ULAND_CFG.
- Reboot the vehicle in order to make the additional configuration parameters visible.
- Set the baud rate parameter for the selected port to the desired value.
- Configure module-specific parameters (i.e. MAVLink streams and data rate configuration).
The GPS/Compass > Secondary GPS section provides a practical example of how to configure a port in QGroundControl (it shows how to use
GPS_2_CONFIG to run a secondary GPS on the
TELEM 2 port).
Port conflicts are handled by system startup, which ensures that at most one service is run on a specific port.
At time of writing there is no user feedback about conflicting ports.
QGroundControl only displays the parameters for services/drivers that are present in firmware. If a parameter is missing, then you may need to add it in firmware.
PX4 firmware includes most drivers by default on Pixhawk-series boards. Flash-limited boards may comment out/omit the driver (at time of writing this only affects boards based on FMUv2).
You can include the missing driver in firmware by uncommenting (or adding) the driver in the default.cmake config file that corresponds to the board you want to build for.
For example, to enable the sf0x driver, you would remove the
# at the beginning of the line below.
You will then need to build the firmware for your platform, as described in Building PX4 Software (PX4 Development Guide).