PX4 自动驾驶用户指南 (v1.13)

# Control Allocation (Mixing)

PX4 takes desired torque and thrust commands from the core controllers and translates them to actuator commands which control motors or servos.

The translation depends on the physical geometry of the airframe. For example, given a torque command to "turn right" (say):

  • A plane with one servo per aileron will command one of servo high and the other low.
  • A multicopter will yaw right by changing the speed of all motors.

PX4 separates this translation logic, which is referred to as "mixing" from the attitude/rate controller. This ensures that the core controllers do not require special handling for each airframe geometry, and greatly improves reusability.

In addition, PX4 abstracts the mapping of output functions to specific hardware outputs. This means that any motor or servo can be assigned to almost any physical output.

Mixing Overview

# Actuator Control Pipeline

Overview of the mixing pipeline in terms of modules and uORB topics (press to show full-screen): Pipeline Overview

Notes:

  • The rate controller outputs torque and thrust setpoints
  • the control_allocator module:
    • handles different geometries based on configuration parameters
    • does the mixing
    • handles motor failures
    • publishes the motor and servo control signals
    • publishes the servo trims separately so they can be added as an offset when testing actuators (using the test sliders).
  • the output drivers:
    • handle the hardware initialization and update
    • use a shared library src/libs/mixer_module (opens new window). The driver defines a parameter prefix, e.g. PWM_MAIN that the library then uses for configuration. Its main task is to select from the input topics and assign the right data to the outputs based on the user set <param_prefix>_FUNCx parameter values. For example if PWM_MAIN_FUNC3 is set to Motor 2, the 3rd output is set to the 2nd motor from actuator_motors.
    • output functions are defined under src/lib/mixer_module/output_functions.yaml (opens new window).
  • if you want to control an output from MAVLink, set the relevant output function to Offboard Actuator Set x, and then send the MAV_CMD_DO_SET_ACTUATOR (opens new window) MAVLink command.

# Adding a new Geometry or Output Function

See this commit (opens new window) for how to add a new geometry. The QGC UI will then automatically show the right configuration UI when CA_AIRFRAME is set to the new geometry.

This commit (opens new window) shows how to add a new output function. Any uORB topic can be subscribed and assigned to a function.

Note that parameters for control allocation are defined in src/modules/control_allocator/module.yaml (opens new window) The schema for this file is here (opens new window) (in particular, search for the key mixer:

# Setting the Default Airframe Geometry

When adding a new airframe configuration, set the appropriate CA_AIRFRAME and and other default values for the mixer.

You can see this, for example, in the airframe configuration file 13200_generic_vtol_tailsitter (opens new window)

....
param set-default CA_AIRFRAME 4
param set-default CA_ROTOR_COUNT 2
param set-default CA_ROTOR0_KM -0.05
param set-default CA_ROTOR0_PY 0.2
...

注解

The CA_* parameters will replace the mixer definition used by default in PX4 v1.13 and earlier:

set MIXER vtol_tailsitter_duo

# Setting up Geometry Mixer and Outputs

The broad geometry and default parameters for a vehicle are set (from the airframe configuration file) when selecting the airframe in QGroundControl: Basic Configuration > Airframe.

The mixer geometry parameters and output mapping for the specific frame and flight controller hardware are then configured using the QGroundControl Actuators setup screen: Basic Configuration > Actuator Configuration and Testing.

← 几何文件 →