Holybro Pixhawk 4 Power Module (PM07)

The Power Management Board (PM Board) serves the purpose of a Power Module as well as a Power Distribution Board. In addition to providing regulated power to Pixhawk 4 and the ESCs, it sends information to the autopilot about battery’s voltage and current supplied to the flight controller and the motors.

Note

This module can be purchased as bundle with Pixhawk 4, but can also be used with other flight controllers.

Specifications

• PCB Current: total 120A outputs (MAX)
• UBEC 5v output current: 3A
• UBEC input voltage: 2~12s LiPo
• Dimensions: 68 x 50 x 8 mm
• Mounting Holes: 45 x 45 mm
• Weight: 36g

Package Contents

• PM07 board
• 80mm XT60 connector wire (installed)
• Electrolytic capacitor: 220uF 63V (installed)
• 2x JST GH 10P Cable
• JST GH 8P Cable
• 2x JST GH 6P Cable

Where to Buy

Pixhawk 4 Power Module (PM07) (opens new window)

Wiring/Connections

Wiring and connection information can be found in: Pixhawk 4 > Power.

Further Information

Quick Start Guide (opens new window) (Holybro)