DroneCAN ESCs
PX4 supports DroneCAN compliant ESCs.
Supported ESC
INFO
Supported ESCs in ESCs & Motors may include additional devices that are not listed below.
The following articles have specific hardware/firmware information:
- PX4 Sapog ESC Firmware
- Zubax Telega
- Vertiq (larger modules)
- VESC Project
- RaccoonLab Cyphal and DroneCAN PWM nodes
硬件配置
General DroneCAN hardware configuration is covered in DroneCAN > Hardware Setup.
DroneCAN ESCs should be on their own dedicated CAN interface(s) because ESC messages can saturate the bus and starve other nodes of bandwidth.
PX4 配置
DroneCAN peripherals are configured by following the procedure outlined in DroneCAN.
In addition to the general setup, such as setting UAVCAN_ENABLE to 3:
- Select the specific CAN interface(s) used for ESC data output using the UAVCAN_ESC_IFACE parameter (all that all interfaces are selected by default).
- Configure the motor order and servo outputs.