# Pixhack v3

PX4 does not manufacture this (or any) autopilot. Contact the [manufacturer](https://store.cuav.net/) for hardware support or compliance issues.

The CUAV Pixhack V3 flight controller board is a flexible autopilot intended primarily for manufacturers of commercial systems.

The board is a variant of the SOLO Pixhawk® 2 (PH2) flight controller, which is in turn based on the Pixhawk-project (opens new window) FMUv3 open hardware design. It runs PX4 on the NuttX (opens new window) OS, and is fully compatible with both PX4 or ArduPilot® (APM) firmware.

Pixhack V3 has significant improvements with respect to the original design, including better interface layout and the addition of vibration damping and a thermostat system.

Pixhack v3

注解

This flight controller is manufacturer supported.

# 快速预览

  • 微处理器:
    • STM32F427
    • STM32F100 (故障保护协处理器)
  • 传感器:
    • 加速度计 (3): LSM303D,MPU6000,MPU6000
    • 陀螺仪 (3): L3GD20, MPU6000, MPU9250
    • 指南针 (2): LS303D, MPU9250
    • 气压计 (2): MS5611*2
  • 接口:
    • MAVLink UART (2)
    • GPS UART (2)
    • DEBUG UART (1)
    • 遥控信号输入(支持PPM, SBUS, DSM/DSM2)
    • RSSI输入: PWM或3.3ADC
    • I2C总线 (2)
    • CAN总线 (1)
    • ADC输入: 3.3V X1 , 6.6V X1
    • PWM输出: 8 PWM IO + 4 IO
  • 电源系统
    • Power口输入电压: 4.5 ~ 5.5 V
    • USB口输入电压:5.0 V +- 0.25v
  • 重量和尺寸:
    • 重量: 63g
    • 宽度:68mm
    • 厚度: 17mm
    • 长度:44mm
  • 其它特性:
    • 工作温度: -20 ~ 60°C

# 访问链接

The board can be purchased from:

# 编译固件

提示

Most users will not need to build this firmware! It is pre-built and automatically installed by QGroundControl when appropriate hardware is connected.

To build PX4 for this target:

make px4_fmu-v3_default

# 引脚和原理图

# Serial Port Mapping

UART 设备 Port
UART1 /dev/ttyS0 IO debug
USART2 /dev/ttyS1 TELEM1 (flow control)
USART3 /dev/ttyS2 TELEM2 (flow control)
UART4
UART7 CONSOLE
UART8 SERIAL4