manual_control_setpoint (UORB message)

source file (opens new window)

uint64 timestamp                        # time since system start (microseconds)
uint64 timestamp_sample                 # the timestamp of the raw data (microseconds)

bool valid

uint8 SOURCE_UNKNOWN   = 0
uint8 SOURCE_RC        = 1      # radio control (input_rc)
uint8 SOURCE_MAVLINK_0 = 2      # mavlink instance 0
uint8 SOURCE_MAVLINK_1 = 3      # mavlink instance 1
uint8 SOURCE_MAVLINK_2 = 4      # mavlink instance 2
uint8 SOURCE_MAVLINK_3 = 5      # mavlink instance 3
uint8 SOURCE_MAVLINK_4 = 6      # mavlink instance 4
uint8 SOURCE_MAVLINK_5 = 7      # mavlink instance 5

uint8 data_source

# Any of the channels may not be available and be set to NaN
# to indicate that it does not contain valid data.
# The variable names follow the definition of the
# MANUAL_CONTROL mavlink message.
# The default range is from -1 to 1 (mavlink message -1000 to 1000)
# The range for the z variable is defined from 0 to 1. (The z field of
# the MANUAL_CONTROL mavlink message is defined from -1000 to 1000)

float32 x            # stick position in x direction -1..1
                 # in general corresponds to forward/back motion or pitch of vehicle,
                 # in general a positive value means forward or negative pitch and
                 # a negative value means backward or positive pitch

float32 y            # stick position in y direction -1..1
                 # in general corresponds to right/left motion or roll of vehicle,
                 # in general a positive value means right or positive roll and
                 # a negative value means left or negative roll

float32 z            # throttle stick position 0..1
                 # in general corresponds to up/down motion or thrust of vehicle,
                 # in general the value corresponds to the demanded throttle by the user,
                 # if the input is used for setting the setpoint of a vertical position
                 # controller any value > 0.5 means up and any value < 0.5 means down

float32 r            # yaw stick/twist position, -1..1
                 # in general corresponds to the righthand rotation around the vertical
                 # (downwards) axis of the vehicle

float32 flaps            # flap position

float32 aux1
float32 aux2
float32 aux3
float32 aux4
float32 aux5
float32 aux6

bool sticks_moving

# TOPICS manual_control_setpoint manual_control_input