# ARK Electronics ARKV6X
WARNING
PX4 does not manufacture this (or any) autopilot. Contact the manufacturer (opens new window) for hardware support or compliance issues.
The USA-built ARKV6X flight controller is based on the FMUV6X and Pixhawk Autopilot Bus open source standards (opens new window).
With triple synced IMUs, data averaging, voting, and filtering is possible. The Pixhawk Autopilot Bus (PAB) form factor enables the ARKV6X to be used on any PAB-compatible carrier board, such as the ARK Pixhawk Autopilot Bus Carrier.
Note
This flight controller is manufacturer supported.
# Where To Buy
Order From Ark Electronics (opens new window) (US)
# Sensors
- Dual Invensense ICM-42688-P IMUs (opens new window)
- Invensense IIM-42652 Industrial IMU (opens new window)
- Bosch BMP390 Barometer (opens new window)
- Bosch BMM150 Magnetometer (opens new window)
# Microprocessor
- STM32H743IIK6 MCU (opens new window)
- 480MHz
- 2MB Flash
- 1MB Flash
# Other Features
- FRAM
- Pixhawk Autopilot Bus (PAB) Form Factor (opens new window)
- LED Indicators
- MicroSD Slot
- USA Built
- Designed with a 1W heater. Keeps sensors warm in extreme conditions
# Power Requirements
- 5V
- 500mA
- 300ma for main system
- 200ma for heater
# Additional Information
- Weight: 5.0 g
- Dimensions: 3.6 x 2.9 x 0.5 cm
# Pinout
For pinout of the ARKV6X see the DS-10 Pixhawk Autopilot Bus Standard (opens new window)
# Serial Port Mapping
UART | Device | Port |
---|---|---|
USART1 | /dev/ttyS0 | GPS |
USART2 | /dev/ttyS1 | TELEM3 |
USART3 | /dev/ttyS2 | Debug Console |
UART4 | /dev/ttyS3 | UART4 & I2C |
UART5 | /dev/ttyS4 | TELEM2 |
USART6 | /dev/ttyS5 | PX4IO/RC |
UART7 | /dev/ttyS6 | TELEM1 |
UART8 | /dev/ttyS7 | GPS2 |
# Building Firmware
make ark_fmu-v6x_default
← 에어마인드 마인드레이서 CUAV X7 →