SensorCorrection (UORB message)

Sensor corrections in SI-unit form for the voted sensor

source file

#
# Sensor corrections in SI-unit form for the voted sensor
#

uint64 timestamp        # time since system start (microseconds)

# Corrections for acceleromter acceleration outputs where corrected_accel = raw_accel * accel_scale + accel_offset
# Note the corrections are in the sensor frame and must be applied before the sensor data is rotated into body frame
uint32[4] accel_device_ids
float32[4] accel_temperature
float32[3] accel_offset_0   # accelerometer 0 offsets in the FRD board frame XYZ-axis in m/s^s
float32[3] accel_offset_1   # accelerometer 1 offsets in the FRD board frame XYZ-axis in m/s^s
float32[3] accel_offset_2   # accelerometer 2 offsets in the FRD board frame XYZ-axis in m/s^s
float32[3] accel_offset_3   # accelerometer 3 offsets in the FRD board frame XYZ-axis in m/s^s

# Corrections for gyro angular rate outputs where corrected_rate = raw_rate * gyro_scale + gyro_offset
# Note the corrections are in the sensor frame and must be applied before the sensor data is rotated into body frame
uint32[4] gyro_device_ids
float32[4] gyro_temperature
float32[3] gyro_offset_0    # gyro 0 XYZ offsets in the sensor frame in rad/s
float32[3] gyro_offset_1    # gyro 1 XYZ offsets in the sensor frame in rad/s
float32[3] gyro_offset_2    # gyro 2 XYZ offsets in the sensor frame in rad/s
float32[3] gyro_offset_3    # gyro 3 XYZ offsets in the sensor frame in rad/s

# Corrections for magnetometer measurement outputs where corrected_mag = raw_mag * mag_scale + mag_offset
# Note the corrections are in the sensor frame and must be applied before the sensor data is rotated into body frame
uint32[4] mag_device_ids
float32[4] mag_temperature
float32[3] mag_offset_0 # magnetometer 0 offsets in the FRD board frame XYZ-axis in m/s^s
float32[3] mag_offset_1 # magnetometer 1 offsets in the FRD board frame XYZ-axis in m/s^s
float32[3] mag_offset_2 # magnetometer 2 offsets in the FRD board frame XYZ-axis in m/s^s
float32[3] mag_offset_3 # magnetometer 3 offsets in the FRD board frame XYZ-axis in m/s^s

# Corrections for barometric pressure outputs where corrected_pressure = raw_pressure * pressure_scale + pressure_offset
# Note the corrections are in the sensor frame and must be applied before the sensor data is rotated into body frame
uint32[4] baro_device_ids
float32[4] baro_temperature
float32 baro_offset_0       # barometric pressure 0 offsets in the sensor frame in Pascals
float32 baro_offset_1       # barometric pressure 1 offsets in the sensor frame in Pascals
float32 baro_offset_2       # barometric pressure 2 offsets in the sensor frame in Pascals
float32 baro_offset_3       # barometric pressure 3 offsets in the sensor frame in Pascals