# MindPX Hardware
PX4 does not manufacture this (or any) autopilot. Contact the manufacturer (opens new window) for hardware support or compliance issues.
The AirMind® MindPX (opens new window) series is a new generation autopilot system branched from Pixhawk®.
These flight controllers are manufacturer supported.
# Quick Summary
The main hardware documentation is here (opens new window).
MindPX is a new generation autopilot system branched from Pixhawk®, been revised in schematic and structure, and been further enhanced with new features to make un-manned vehicle more smart and more friendly to use.
MindPX increases total PWM output channels to 16 (8 main outputs + 8 aux outputs). This means that MindPX can support more complicated VTOL configurations and more fine control. It is especially meaningful for those FMU-V4 based flight controllers as MindPX implements main and aux output in one single FMU.
Main System-on-Chip: STM32F427
- CPU: 32bits, 168 MHz ARM Cortex® M4 with FPU
- RAM: 256 KB SRAM
- 2MB Flash
- ST Micro LSM303D 14 bit accelerometer/magnetometer
- MEAS MS5611 barometer
- InvenSense® MPU6500 integrated 6-axis sensors
- CNC processed aluminum alloy case, light and solid
- Built-in isolated IMU redundancy
- Total 16 PWM output channel (8 main + 8 aux)
- 1 extra I2C port for flow connection.
- 1 extra USB port for companion computer connection (built-in UART-to-USB converter)
- Exposed debug port for development
# Quick Start
|2||Debug (refresh bootloader)||10||USB2 (Serial 2 to USB)|
|3||USB1 (refresh firmware)||11||UART4,5|
|7||TF card slot||15||Tricolor Light|
# Radio Receiver
MindPX supports a wide variety of radio receivers (since V2.6) including: PPM/SBUS/DSM/DSM2/DSMX. MindPX also support FrSky® bi-direction telemetry D and S.Port.
For detailed Pin diagram, please refer to the User Guide (opens new window).
# Building Firmware
Most users will not need to build this firmware! It is pre-built and automatically installed by QGroundControl when appropriate hardware is connected.
To build PX4 for this target:
# Companion PC connection
MindPX has a USB-TO-UART Bridge IC on the board. A micro-USB to USB type A cable is used for the connection. Connect micro-USB end to the 'OBC' port of MindPX and USB type A end to companion computer.
And the max BAUD rate is the same with px4 family, which is up to 921600.
# User Guide
The user guide is here (opens new window).
# Where to Buy
MindRacer is available at AirMind Store (opens new window) on internet. You can also find MindRacer at Amazon® or eBay®.
# Serial Port Mapping
Please visit http://www.mindpx.org for more information. Or you can send email to email@example.com for any inquiries or help.