Skip to content

Holybro PM02 (V3) Power Module

This analog power module provides regulated power to flight controller and power distribution board, and sends information to the autopilot about battery voltage and current supplied to the flight controller and the motors. It is commonly used with Pixhawk 4.

INFO

The module can be used with other flight controllers that require an analog power module, including Durandal, Pix32 v5, etc

Holybro PM02

Specifications

  • Rated current: 60A
  • Max current: 120A (<60 Sec)
  • Max current sensing: 120A
  • Battery supported: up to 12S battery
  • Communication protocol: Analog
  • Switching regulator outputs: 5.2V and 3A max
  • Weight: 20g

Voltage and current measurement configured for 3.3V ADC

Package Contents

  • Power Module with XT60 Connector Board
  • Electrolytic capacito: 220uF 63V (pre-installed)
  • Molex 6 Position Connector 15 cm
  • GH 6 Position Connector 15 cm

Where to Buy

Order from Holybro Store

Wiring/Connections

Additional wiring and connection information can be found in: Pixhawk 4 QuickStart.