Benewake TFmini LiDAR
The Benewake TFmini LiDAR is a tiny, low cost, and low power LIDAR with 12m range.
PX4 supports all three variants in the series: TFmini-s, TFmini-i, TFmini Plus. These must be connected to a UART/serial bus.
Where to Buy
- TFmini-s
- TFmini-i (industrial)
- TFmini Plus
硬件安装
TFmini can be connected to any unused serial port (UART), such as: TELEM2, TELEM3, GPS2 etc.
Parameter Setup
Configure the serial port on which the lidar will run using SENS_TFMINI_CFG. There is no need to set the baud rate (this is hard coded in the sensor driver as only one rate is supported).
If the configuration parameter is not available in QGroundControl then the tfmini driver may not be in firmware. For information on how to add it see: