Pixhack v3

PX4 does not manufacture this (or any) autopilot. Contact the manufacturer for hardware support or compliance issues.

The CUAV Pixhack V3 flight controller board is a flexible autopilot intended primarily for manufacturers of commercial systems.

The board is a variant of the SOLO Pixhawk^® 2 (PH2) flight controller, which is in turn based on the Pixhawk-project FMUv3 open hardware design. It runs PX4 on the NuttX OS, and is fully compatible with both PX4 or ArduPilot^® (APM) firmware.

Pixhack V3 has significant improvements with respect to the original design, including better interface layout and the addition of vibration damping and a thermostat system.

This flight controller is manufacturer supported.

快速预览

• 微处理器：
  • STM32F427
  • STM32F100 (故障保护协处理器)
• 传感器：
  • 加速度计 (3): LSM303D,MPU6000,MPU6000
  • 陀螺仪 (3): L3GD20, MPU6000, MPU9250
  • 指南针 (2): LS303D, MPU9250
  • 气压计 (2): MS5611*2
• 接口：
  • MAVLink UART (2)
  • GPS UART (2)
  • DEBUG UART (1)
  • 遥控信号输入(支持PPM, SBUS, DSM/DSM2)
  • RSSI输入: PWM或3.3ADC
  • I2C总线 (2)
  • CAN总线 (1)
  • ADC输入: 3.3V X1 , 6.6V X1
  • PWM输出: 8 PWM IO + 4 IO
• 电源系统
  • Power口输入电压: 4.5 ~ 5.5 V
  • USB口输入电压：5.0 V +- 0.25v
• 重量和尺寸:
  • 重量: 63g
  • 宽度：68mm
  • 厚度: 17mm
  • 长度：44mm
• 其它特性:
  • 工作温度: -20 ~ 60°C

访问链接

The board can be purchased from:

• store.cuav.net
• leixun.aliexpress.com/store

编译固件

TIP

Most users will not need to build this firmware! It is pre-built and automatically installed by QGroundControl when appropriate hardware is connected.

To build PX4 for this target:

make px4_fmu-v3_default

引脚和原理图

• Documentation/wiring guides

Serial Port Mapping

UART	设备	Port
UART1	/dev/ttyS0	IO debug
USART2	/dev/ttyS1	TELEM1 (flow control)
USART3	/dev/ttyS2	TELEM2 (flow control)
UART4
UART7	CONSOLE
UART8	SERIAL4