# Holybro DroneCAN M8N GPS
The Holybro DroneCAN GPS has an UBLOX M8N module, BMM150 compass, tri-colored LED indicator.
The GPS module uses the DroneCAN protocol for communication. DroneCAN connections are more resistant to electromagnetic interference compared to serial connection, making it more reliable. In addition, using DroneCAN means that the GPS and compass do not occupy any flight controller serial ports (different/additional CAN devices can be connected to the same CAN bus via a CAN splitter board).
# Where to Buy
Order this module from:
# Hardware Specifications
|GNSS Receiver||Ublox NEO M8N|
|Number of Concurrent GNSS||2 (Default GPS + GLONASS)|
|Processor||STM32G4 (170MHz, 512K FLASH)|
|GNSS Augmentation System||SBAS: WAAS, EGNOS, MSAS, QZSS|
|Navigation Update||5Hz Default(10Hz MAX)|
|Navigation sensitivity||–167 dBm|
|Cold starts||~ 26s|
|Speed Accuracy||0.05 m/s|
|Max # of Satellites||22+|
|Default CAN BUS data rate||1MHz|
|Communication Protocol||DroneCAN @ 1 Mbit/s|
|Supports Autopilot FW||PX4, Ardupilot|
|Antenna||25 x 25 x 4 mm ceramic patch antenna|
|Power consumption||Less than 200mA @ 5V|
# Hardware Setup
The recommended mounting orientation is with the arrow on the GPS pointing towards the front of vehicle.
The sensor can be mounted anywhere on the frame, but you will need to specify its position, relative to vehicle centre of gravity, during PX4 configuration.
The Holybro DroneCAN GPS is connected to the CAN bus using a Pixhawk standard 4 pin JST GH cable. For more information, refer to the CAN Wiring instructions.
# PX4 Configuration
You need to set necessary DroneCAN parameters and define offsets if the sensor is not centred within the vehicle. The required settings are outlined below.
The GPS will not boot if there is no SD card in the flight controller when powered on.
# Enable DroneCAN
The steps are:
- In QGroundControl set the parameter UAVCAN_ENABLE to
3and reboot (see Finding/Updating Parameters).
- Connect GPS CAN to the Pixhawk CAN.
Once enabled, the module will be detected on boot. GPS data should arrive at 5Hz.
DroneCAN configuration in PX4 is explained in more detail in DroneCAN > Enabling DroneCAN.
# Sensor Position Configuration
If the sensor is not centred within the vehicle you will also need to define sensor offsets:
- Enable GPS yaw fusion by setting bit 3 of EKF2_GPS_CTRL to true.
- Enable UAVCAN_SUB_GPS, UAVCAN_SUB_MAG, and UAVCAN_SUB_BARO.
- Set CANNODE_TERM to
1if this is that last node on the CAN bus.
- The parameters EKF2_GPS_POS_X, EKF2_GPS_POS_Y and EKF2_GPS_POS_Z can be set to account for the offset of the ARK GPS from the vehicles centre of gravity.