Modules Reference: Adc (Driver)
TLA2528
Source: drivers/adc/tla2528
Usage
TLA2528 <command> [arguments...]
Commands:
start
[-I] Internal I2C bus(es)
[-X] External I2C bus(es)
[-b <val>] board-specific bus (default=all) (external SPI: n-th bus
(default=1))
[-f <val>] bus frequency in kHz
[-q] quiet startup (no message if no device found)
stop
status print status infoadc
Source: drivers/adc/board_adc
Description
ADC driver.
Usage
adc <command> [arguments...]
Commands:
start
test
[-n] Do not publish ADC report, only system power
stop
status print status infoads1115
Source: drivers/adc/ads1115
Description
Driver to enable an external ADS1115 ADC connected via I2C.
The driver is included by default in firmware for boards that do not have an internal analog to digital converter, such as PilotPi or CUAV Nora (search for CONFIG_DRIVERS_ADC_ADS1115 in board configuration files).
It is enabled/disabled using the ADC_ADS1115_EN parameter, and is disabled by default. If enabled, internal ADCs are not used.
Usage
ads1115 <command> [arguments...]
Commands:
start
[-I] Internal I2C bus(es)
[-X] External I2C bus(es)
[-b <val>] board-specific bus (default=all) (external SPI: n-th bus
(default=1))
[-f <val>] bus frequency in kHz
[-q] quiet startup (no message if no device found)
[-a <val>] I2C address
default: 72
stop
status print status infoads7953
Source: drivers/adc/ads7953
Usage
ads7953 <command> [arguments...]
Commands:
start
[-s] Internal SPI bus(es)
[-S] External SPI bus(es)
[-b <val>] board-specific bus (default=all) (external SPI: n-th bus
(default=1))
[-c <val>] chip-select pin (for internal SPI) or index (for external SPI)
[-m <val>] SPI mode
[-f <val>] bus frequency in kHz
[-q] quiet startup (no message if no device found)
stop
status print status info