Holybro PM02 (V3) Power Module
This analog power module provides regulated power to flight controller and power distribution board, and sends information to the autopilot about battery voltage and current supplied to the flight controller and the motors. It is commonly used with Pixhawk 4.
The module can be used with other flight controllers that require an analog power module, including Durandal, Pix32 v5, etc
Specifications
- Rated current: 60A
- Max current: 120A (<60 Sec)
- Max current sensing: 120A
- Battery supported: up to 12S battery
- Communication protocol: Analog
- Switching regulator outputs: 5.2V and 3A max
- Weight: 20g
Voltage and current measurement configured for 3.3V ADC
Package Contents
- Power Module with XT60 Connector Board
- Electrolytic capacito: 220uF 63V (pre-installed)
- Molex 6 Position Connector 15 cm
- GH 6 Position Connector 15 cm
Where to Buy
Wiring/Connections
Additional wiring and connection information can be found in: Pixhawk 4 QuickStart.