ThePeach FCC-R1

WARNING

PX4 does not manufacture this (or any) autopilot. Contact the manufacturer for hardware support or compliance issues.

ThePeach FCC-R1 is an advanced autopilot designed and made in ThePeach.

It is based on the Pixhawk-project FMUv3 open hardware design and runs PX4 on Nuttx OS.

产品规格

• Main Processor: STM32F427VIT6

  • 32bit ARM Cortex-M4, 168 MHz 256 KB RAM 2 MB Flash memory

• IO Processor: STM32F100C8T6

  • ARM Cortex-M3, 32bit ARM Cortex-M3, 24 MHz, 8KB SRAM

• On-board sensors

  • 加速度计 / 陀螺仪：ICM-20602
  • Accel/Gyro/Mag: MPU-9250
  • 气压计：MS5611

• 接口

  • 8+6 PWM output (8 from IO, 6 from FMU)
  • Spektrum DSM / DSM2 / DSM-X Satellite compatible input
  • Futaba S.BUS compatible input and output
  • PPM sum signal input
  • Analogue / PWM RSSI input
  • S.BUS伺服输出
  • Safety switch/LED
  • 4x UART: TELEM1, TELEM2(Raspberry Pi CM3+), GPS, SERIAL4
  • 1x I2C Ports
  • 1x CAN bus
  • Analog inputs for voltage / Current of 1 battery

• Interfaces For Raspberry Pi CM3+

  • VBUS
  • DDR2 Connector: Raspberry Pi CM3+
  • 1x UART
  • 2x USB
  • 1x Raspberry Pi Camera

• Mechanical

  • Dimensions: 49.2 x 101 x 18.2mm
  • Weight: 100g

连接器

串口映射

UART	设备	Port
USART1	/dev/ttyS0	IO Processor Debug
USART2	/dev/ttyS1	TELEM1 (flow control)
USART3	/dev/ttyS2	TELEM2 (Raspberry pi cm3+)
UART4	/dev/ttyS3	GPS1
USART6	/dev/ttyS4	PX4IO
UART7	/dev/ttys5	Debug console
UART8	/dev/ttyS6	TELEM4

额定电压

ThePeach FCC-R1 can be double-redundant on the power supply if two power sources are supplied. The two power rails are: POWER and USB.

注意：

1. The output power rails FMU PWM OUT and I/O PWM OUT do not power the flight controller board (and are not powered by it). You must supply power to one of POWER or USB or the board will be unpowered.
2. The USB do not power the Raspberry Pi CM3+. You must supply power to POWER or the Raspberry Pi CM3+ will be unpowered.

Normal Operation Maximum Ratings

Under these conditions, all power sources will be used in this order to power the system:

1. POWER input (5V to 5.5V)
2. USB input (4.75V to 5.25V)

Absolute Maximum Ratings

Under these conditions, all power sources cause permanent damage to the flight controller.

1. POWER input (5.5V Over)

2. USB input (5.5V Over)

编译固件

To build PX4 for this target:

make thepeach_r1_default

Where to buy

Order from ThePeach