Holybro Kakute H7 V2

WARNING

PX4 does not manufacture this (or any) autopilot. Contact the manufacturer for hardware support or compliance issues.

The Holybro Kakute H743 Wing is a fully featured flight controller specifically aimed at fixed-wing and VTOL applications. It has the STM32 H743 Processor running at 480 MHz and CAN Bus support, along with dual camera support & switch, ON/OFF Pit Switch, 5V, 6V/8V, 9V/12 BEC, and plug-and-play GPS, CAN, I2C ports.

INFO

This flight controller is manufacturer supported.

구매처

The board can be bought from one of the following shops (for example):

• Holybro

커넥터 및 핀

핀	기능	기본값
GPS 1	USART1 and I2C1	GPS1
R2, T2	USART2 RX and TX	GPS2
R3, T3	USART3 RX and TX	TELEM1
R5, T5	USART5 RX and TX	TELEM2
R6, T6	USART6 RX and TX	RC (PPM, SBUS, etc.) input
R7, T7, RTS, CTS	UART7 RX and TX with flow control	TELEM3
R8, T8	UART8 RX and TX	Console
Buz-, Buz+	Piezo buzzer
M1 to M14	Motor signal outputs

부트로더 업데이트

The board comes pre-installed with Betaflight. Before the PX4 firmware can be installed, the PX4 bootloader must be flashed. Download the holybro_kakuteh7-wing.hex bootloader binary and read this page for flashing instructions.

펌웨어 빌드

To build PX4 for this target:

make holybro_kakuteh7-wing_default

펌웨어 설치

INFO

KakuteH7-wing is supported with PX4 master & PX4 v1.16 or newer.. Prior to that release you will need to manually build and install the firmware.

Firmware can be manually installed in any of the normal ways:

• Build and upload the source:

  make holybro_kakuteh7-wing_default upload

• Load the firmware using QGroundControl. 미리 빌드된 펌웨어나 사용자 지정 펌웨어를 사용할 수 있습니다.

시리얼 포트 매핑

UART	장치	포트	Default function
USART1	/dev/ttyS0	GPS 1	GPS1
USART2	/dev/ttyS1	R2, T2	GPS2
USART3	/dev/ttyS2	R3, T3	TELEM1
UART5	/dev/ttyS3	R5, T5	TELEM2
USART6	/dev/ttyS4	R6, (T6)	RC 입력
UART7	/dev/ttyS5	R7, T7, RTS, CTS	TELEM3
UART8	/dev/ttyS6	R8, T8	Console

디버그 포트

시스템 콘솔

UART8 RX and TX are configured for use as the System Console.