듀얼 u-blox F9P를 사용한 RTK GPS 헤딩
Two u-blox F9P RTK GPS modules mounted on a vehicle can be used to accurately compute a heading angle (i.e. an alternative to compass-based heading estimation). The two GPS devices in this scenario are referred to as the Moving Base and Rover.
지원되는 RTK 장치
This feature works on F9P devices that support CAN or expose the GPS UART2 port.
The following devices are supported:
- ARK RTK GPS (arkelectron.com)
- SparkFun GPS-RTK2 Board - ZED-F9P (www.sparkfun.com)
- SIRIUS RTK GNSS ROVER (F9P) (store-drotek.com)
- mRo u-blox ZED-F9 RTK L1/L2 GPS (store.mrobotics.io)
- Holybro H-RTK F9P Helical or Base (Holybro Store)
- Holybro DroneCAN H-RTK F9P Rover or Helical (Holybro Store)
- CUAV C-RTK 9Ps (CUAV Store)
INFO
- Freefly RTK GPS and Holybro H-RTK F9P Rover Lite cannot be used because they do not expose the CAN or UART2 port.
- Supported devices are also listed in RTK GNSS (GPS) > Supported Devices.
설정
Ideally the two antennas should be identical, on the same level/horizontal plane and oriented the same way, and on an identical ground plane size and shape (Application note, section System Level Considerations).
- 애플리케이션 노트에는 모듈 사이에 필요한 최소 간격이 명시되어 있지 않습니다 (PX4를 실행하는 테스트 차량에 50cm가 사용되었습니다).
- The antennas can be positioned as needed, but the GPS_YAW_OFFSET must be configured: RTK GPS > GPS as Yaw/Heading Source.
UART Setup
- The UART2 of the GPS devices need to be connected together (TXD2 of the "Moving Base" to RXD2 of the "Rover")
- Connect UART1 on each of the GPS to (separate) unused UART's on the autopilot, and configure both of them as GPS with baudrate set to
Auto. The mapping is as follows:- Main GPS = Rover
- Secondary GPS = Moving Base
- Set GPS_UBX_MODE to
Heading(1) - EKF2_GPS_CTRL parameter bit 3 must be set (see RTK GPS > GPS as Yaw/Heading Source).
- GPS_YAW_OFFSET may need to be set (see RTK GPS > GPS as Yaw/Heading Source).
- Reboot and wait until both devices have GPS reception.
gps statusshould then show the Main GPS going into RTK mode, which means the heading angle is available.
CAN Setup
Refer to the CAN RTK GPS documentation for each specific device for the setup instructions (such as ARK RTK GPS > Setting Up Moving Baseline & GPS Heading)
INFO
If using RTK with a fixed base station the secondary GPS will show the RTK state w.r.t. the base station.
추가 정보
- ZED-F9P Moving base applications (Application note) - General setup/instructions.
- RTK GPS > GPS as Yaw/Heading Source