ARK G5 RTK HEADING GPS

INFO

This GPS module is made in the USA and NDAA compliant.

ARK G5 RTK HEADING GPS is a DroneCAN quad-band dual antenna RTK GPS that additionally provides vehicle yaw information from GPS.

The module incorporates the Septentrio mosaic-G5 P3H Ultra-compact high-precision GPS/GNSS receiver module with heading capability, magnetometer, barometer, IMU, and buzzer module.

Де купити

Замовте цей модуль з:

• ARK Electronics (US)

Характеристики обладнання

• DroneCAN RTK GNSS, Magnetometer, Barometer, IMU, and Buzzer Module
• Dronecan Firmware Updating
• Датчики
  • Septentrio mosaic-G5 P3H Ultra-compact high-precision GPS/GNSS receiver module with heading capability
    • All-band all constellation GNSS receiver
    • All-in-view satellite tracking: multi-constellation, quad-band GNSS module receiver
    • Full raw data with positioning measurements and Galileo HAS positioning service compatibility
    • Best-in-class RTK cm-level positioning accuracy
    • Advanced GNSS+ algorithms
    • 20Hz update rate
  • ST IIS2MDC Magnetometer
  • Bosch BMP390 Barometer
  • Invensense ICM-42688-P 6-Axis IMU
• STM32F412VGH6 MCU
• Кнопка безпеки
• Зумер
• Two CAN Connectors (Pixhawk Connector Standard 4-pin JST GH)
• G5 "UART 2" Connector
  • 4-pin JST GH
  • TX, RX, PPS, GND
• G5 USB C
• Debug Connector (Pixhawk Connector Standard 6-pin JST SH)
• LED індикатори
  • GPS Fix
  • Статус RTK
  • RGB Статус системи
• USA Built
• NDAA Compliant
• Вимоги до живлення
  • 5V
    • 270mA
• Розміри
  • Without Antenna
    • 48.0mm x 40.0mm x 15.4mm
    • 13.0g
  • With Antenna
    • 48.0mm x 40.0mm x 51.0mm
    • 43.5g
• Includes
  • CAN Cable (Pixhawk Connector Standard 4-pin)
  • Full-Frequency Helical GPS Antenna

Налаштування програмного забезпечення

Підключення

The ARK G5 RTK HEADING GPS is connected to the CAN bus using a Pixhawk connector standard 4-pin JST GH cable. For more information, refer to the CAN Wiring instructions.

Встановлення

The recommended mounting orientation is with the connectors on the board pointing towards the back of vehicle.

The sensor can be mounted anywhere on the frame, but you will need to specify its position, relative to vehicle centre of gravity, during PX4 configuration.

Налаштування прошивки

The Septentrio G5 module firmware can be updated using the Septentrio RxTools application.

Налаштування польотного контролера

Увімкнення DroneCAN

In order to use the ARK G5 RTK HEADING GPS, connect it to the Pixhawk CAN bus and enable the DroneCAN driver by setting parameter UAVCAN_ENABLE to 2 for dynamic node allocation (or 3 if using DroneCAN ESCs).

Кроки наступні:

• In QGroundControl set the parameter UAVCAN_ENABLE to 2 or 3 and reboot (see Finding/Updating Parameters).
• Connect ARK G5 RTK HEADING GPS CAN to the Pixhawk CAN.

Після активації модуль буде виявлено при завантаженні.

There is also CAN built-in bus termination via CANNODE_TERM

Конфігурація PX4

You need to set necessary DroneCAN parameters and define offsets if the sensor is not centred within the vehicle:

• Enable GPS yaw fusion by setting bit 3 of EKF2_GPS_CTRL to true.
• Enable GPS blending to ensure the heading is always published by setting SENS_GPS_MASK to 7 (all three bits checked).
• Enable UAVCAN_SUB_GPS, UAVCAN_SUB_MAG, and UAVCAN_SUB_BARO.
• The parameters EKF2_GPS_POS_X, EKF2_GPS_POS_Y and EKF2_GPS_POS_Z can be set to account for the offset of the ARK G5 RTK HEADING GPS from the vehicle's centre of gravity.

Parameter references

This GPS is using ARK's private driver, the prameters below only exist on the firmware we ship the GPS with. You can set these params either in QGC or using the DroneCAN GUI Tool.

SEP_OFFS_YAW (float)

Heading offset angle for dual antenna GPS setups that support heading estimation. Set this to 0 if the antennas are parallel to the forward-facing direction of the vehicle and the Rover/ANT2 antenna is in front. The offset angle increases clockwise. Set this to 90 if the ANT2 antenna is placed on the right side of the vehicle and the Moving Base/MAIN antenna is on the left side.

• Default: 0
• Min: -360
• Max: 360
• Unit: degree

SEP_OFFS_PITCH (float)

Vertical offsets can be compensated for by adjusting the Pitch offset. Note that this can be interpreted as the "roll" angle in case the antennas are aligned along the perpendicular axis. This occurs in situations where the two antenna ARPs may not be exactly at the same height in the vehicle reference frame. Since pitch is defined as the right-handed rotation about the vehicle Y axis, a situation where the main antenna is mounted lower than the aux antenna (assuming the default antenna setup) will result in a positive pitch.

• Default: 0
• Min: -90
• Max: 90
• Unit: degree

SEP_OUT_RATE (enum)

Configures the output rate for GNSS data messages.

• -1: OnChange (Default)
• 50: 50 ms
• 100: 100 ms
• 200: 200 ms
• 500: 500 ms

Значення LED індикаторів

The GPS status lights are located to the right of the connectors:

• Миготіння зеленого - це фіксація GPS
• Миготіння синього - це отримані корекції та RTK Float
• Сталий синій - це RTK зафіксовано

Дивіться також

• ARK G5 RTK HEADING GPS Documentation (ARK Docs)