ARK DAN GPS
ARK DAN GPS is a made in the USA and NDAA-compliant GNSS/GPS u-blox DAN-F10N GPS and industrial magnetometer.
Де купити
Замовте цей модуль з:
- ARK Electronics (US)
Характеристики обладнання
- Open Source Schematic and BOM
- Датчики
- u-blox DAN-F10N
- L1/L5/E5a/B2a bands
- Consistently strong performance regardless of installation
- Integrated SAW-LNA-SAW for exceptional out-of-band jamming immunity
- u-blox F10 proprietary dual-band multipath mitigation technology
- ST IIS2MDC Magnetometer
- u-blox DAN-F10N
- Pixhawk Standard UART/I2C Connector (6 Pin JST SH)
- Вимоги до живлення
- 5V
- 25mA Average
- 44mA Max
- LED індикатори
- GPS Fix
- USA Built
- NDAA Compliant
- 6 Pin Pixhawk Standard UART/I2C Cable
Налаштування обладнання
The module comes with a Pixhawk-standard 6pin connector that will plug into the GPS2 port on recent Pixhawk flight controllers. It should be mounted front facing, as far away from the flight controller and other electronics as possible.
For more information see Mounting the GNSS/Compass and Hardware Setup.
Конфігурація PX4
The module should be plug-n-play when used with the GPS2 port on most flight controllers.
Secondary GPS Configuration (UART) explains how you can configure the port if the GPS is not detected (note, that the configuration is the same, even if you are using GPS 2 as the primary compass).
Схема розташування виводів
Pixhawk Standard UART/I2C Connector - 6 Pin JST-SH
| Pin Number | Signal Name | Напруга |
|---|---|---|
| 1 | 5V | 5.0V |
| 2 | RX | 3.3V |
| 3 | TX | 3.3V |
| 4 | SCL | 3.3V |
| 5 | SDA | 3.3V |
| 6 | GND | GND |
Дивіться також
- ARK DAN GPS Documentation (ARK Docs)