Holybro PM02D Енергогенератор
The Holybro PM02D digital power module provides regulated power to flight controller and power distribution board, and sends information to the autopilot about battery voltage and current supplied to the flight controller and the motors.
Плата живлення підключається за допомогою протоколу I2C. It is designed for flight controllers based on the Pixhawk FMUv5X and FMUv6X open standard, including the Pixhawk 5X.
INFO
The PM is NOT compatible with flight controllers that require an analog power module, including: Pixhawk 4, Durandal, Pix32 v5, etc.
Характеристики
- Max input voltage: 36V
- Rated current: 60A
- Max current: 120A (<60S)
- Max current sensing: 164A
- Battery supported: up to 6S battery
- Communication protocol: I2C
- Switching regulator outputs: 5.2V and 3A max
- Weight: 20g
- IC Used: TI INA228
Вміст набору
- PM02D дошка з коннекторами XT60
- 6pin 2.00мм інтервал CLIK-Mate кабель до протиживлення контролера
Де купити
Проведення/Підключення
Additional wiring and connection information can be found in: Holybro Pixhawk 5x Wiring Quick Start.
Конфігурація PX4
Enable parameter SENS_EN_INA228
WARNING
There is an out-of-production low voltage version (6S) of this module with the same name, which uses the TI INA226 IC. For this module you must instead enable parameter SENS_EN_INA226.
Note that the current divider and voltage divider should not be set in the Battery Configuration (the default values are accurate within 5%).
Дивіться також
- Digital Power Module (PM) Setup (Manufacturer guide)